The LED usage and maintenance instructions are as follows:

1. After purchasing the light fixture, do not rush to install it. Please read the installation instructions carefully and install the fixture according to the instructions; otherwise, danger may occur.

2. During cleaning and maintenance, do not alter the structure of the light fixture or replace any of its components at will. After maintenance, reinstall the fixture as it was originally assembled, ensuring that no components are missing or incorrectly installed.

4. When using the light, please avoid switching it on and off frequently. Although the number of switching cycles of an LED light is approximately 18 times that of an ordinary fluorescent lamp, excessively frequent switching will still affect the service life of the electronic components inside the LED light, thereby affecting the service life of the light.

5. It is particularly important to note that, except for specially designed LED light fixtures, ordinary LED light fixtures should not be used in damp environments. Damp environments can affect the electronic components of the LED driver power supply. When the electronic components become damp, the service life of the light fixture will be shortened.

Therefore, moisture protection is essential for maintaining light fixtures, especially LED lights in toilets and bathrooms and stove lights in kitchens. A moisture-proof lampshade must be installed to prevent moisture from entering, causing rust, damage, electrical leakage, or short circuits.

Finally, do not wash LED lights with water. Simply wipe them with a dry cloth moistened with water. If they accidentally come into contact with water, try to wipe them as dry as possible. After turning on the light, do not immediately wipe it with a wet cloth.

Important notice:
1) Ordinary LED lights cannot be used in the circuits of dimmable desk lamps, delay switches, or sensor switches.
2) Avoid using them in high-temperature and high-humidity environments.
3) The interior of an LED light mainly consists of a power supply driver. Non-professionals are advised not to assemble, disassemble, or reassemble it themselves, in order to avoid dangers such as electric shock.
4) LED light fixtures are generally used when the ambient temperature is 5-40°C.
5) Do not use polishing powder or other chemical agents on the metal parts of LED light fixtures.
6) Dust on the back of ED light fixtures should be cleaned with a dry cloth or a dust collector.